Kawasaki Ninja 650 & Z650 Fender Eliminator Modification for 2020+ Models

We are aware that our current fender eliminator offering for the Kawasaki Ninja 650 and Z650 does not currently install on 2020+ models without modification.  Specifically the turn signal electrical connector is too big to pass through the rectangular hole in the  fender eliminator shown below.   
We will release a properly updated design (target late September 2022) however if you would prefer to not wait and modify our current part it is relatively easy.  You can use a file or dremel to open the cutout until the connector passes through, or if you have a 3/4" step drill you can use that to make a clean circular hole for the connector to pass through